首頁 >> 供求商機
貨物所在地：廣東廣州市
所在地： 美國
更新時間：2024-12-21 21:00:07
瀏覽次數：253
在線詢價收藏產品( 聯系我們,，請說明是在 化工儀器網 上看到的信息,，謝謝?。?/p>
TPI-708燃燒效率分析儀介紹：
煙氣分析儀/燃燒效率分析儀TPI708三合一氣體燃燒效率分析儀除了測量O2/CO/CO2之外,，還可做燃燒效率分析，并且結合微分溫度計,，配合印表儲存之數據,。TPI708開機時進行一系列的傳感器檢測，以確保工作正常,，TPI708必須在潔凈空氣環境下開機,，如果在開機時傳感器工作不正常或沒有正確歸零,，顯示屏將顯示錯誤信息,。TPI708可存儲數據50筆。
The TPI 708 Flue Gas Analyzer is a state of the art, easy to use analyzer designed not only to display and calculate the required readings from a flue but also to cover most of the other measurements associated with combustion.The instrument is ruggedly constructed and comes with a 3 Year unitand 2 Year sensor Guarantee.
The TPI 708 combustion analyzer uses state of the art electrochemical sensors. This sensor technology provides the longest lasting, most accurate and reliable means for performing combustion tests. The sensors in your analyzer will need to be replaced periodically and calibration is recommended once every year. The 708 will remind you when calibration is due by flashing “CAL DUE Err” for three seconds at start up.
Electrochemical sensors by nature are always active. Therefore the time the analyzer is off and not being used must be taken into account when determining sensor life. The sensors in your analyzer are warranted for two years. This warranty does not cover sensors damaged through misuse of the analyzer.
You should keep the batteries of your 708 fresh so power is constantly being supplied to your sensors.
The following guidelines will help prevent damage to your sensors:
Always use the mini pump filter when testing flue gases.
Always periodically check and replace the mini pump filter as needed.
Always make sure the in-line filter / water trap is installed properly.
Always periodically check and replace the in-line filter as needed.
Always remove water or condensation from the inside of the in-line filter / water trap assembly prior to performing tests.
Always use the optional oil filter (p/n A773) when performing tests on oil burning equipment.
Never over saturate your sensors by performing tests on equipment with gas levels beyond the capability of you analyzer.
Always keep the A794 water trap / filter assembly clean and replace the filter as necessary. Replacement filter part number is A794F.
The TPI 708 Flue Gas Analyzer comes complete with the following standard accessories:
TPI 708 Instrument
Rubber Boot (A765)
Soft Carrying Case (A768)
Flue Sampling Probe (A770)
In-Line Filter assembly installed on Flue probe (A794)
Temperature Probe (GK11M)
Mini Pump Protection Filter Assembly and spare filters (A763)
Exhaust Spigot (removable) (A764)
Instruction Manual
The TPI 708 Flue Gas Analyzer has the following options available:
Infrared printer (A740)
Spare In-Line Filter (A794F is a package of 5 filters)
6