96-roundwell microplate 300 rpm

96-roundwell microplate 300 rpm

96圓井微板孔內流體力學

對于96個圓孔板,，使用0.1至0.2毫升的培養體積,，在50毫米振幅的振動篩上以300轉/分的速度進行培養,。這種振動條件導致氧傳輸速率為20-40mmol/O2/L/h（對應于100-200 H-1的KLA值）,。對于良好的混合，我們建議使用不超過0.15毫升培養體積（或者如果需要更高的氧傳輸速率甚至更少）,。如此低的培養體積使離心后的上清液很難取出,。一個更容易做到這一點的技巧是在離心之前加入等量的水或緩沖液（例如0.15ml ul）。請注意,，在搖動條件下，你幾乎沒有空間進行操作：需要小2.5g的離心力（如50 mm/300 rpm）來克服表面張力,，這樣就可以*混合到底部,，防止“死區”,。

50毫米振動篩振幅•300轉/分

Hydrodynamics inside wells of a 96-roundwell microplate
For 96-roundwell plates, culture volumes between 0.1  and 0.2  ml are used, preferably at 300 rpm on a shaker with a 50 mm amplitude. This shaking condition leads to oxygen-transfer rates of 20-40 mmol O2/L/h (corresponding to kLa values of 100-200 h-1).For a good mixing, we advice to use no more than 0.15 ml culture volume (or even less if higher oxygen-transfer rates are needed). Such low culture volumes make it difficult to take off the supernatant after centrifugation. A trick to make this easier is to add an equal volume (so e.g. 0.15 ml ul) of water or buffer prior to centrifugation.Please note that you have little room to manouvre with regard to the shaking conditions: a centrifugal force in the order of minimally 2.5 g (as with 50 mm/300 rpm) is needed to overcome the surface tension, and so to obtain full mixing down to the bottom of the culture, and prevent “ dead zones”
50 mm shaker amplitude•300 rpm

 注：楊清辰發布