BR-PV-WLC with Spray 濕漏電流測試系統及噴淋裝置
- 公司名稱 上海泊??茖W(xué)儀器有限公司
- 品牌
- 型號 BR-PV-WLC with Spray
- 產地 上海市閔行區
- 廠商性質 生產廠家
- 更新時間 2018/5/14 9:00:00
- 訪問次數 4369
聯系我們時請說明是化工儀器網上看到的信息,,謝謝!
穩態模擬器及I-V測試儀,組件戶外測試系統,紫外預處理試驗機,引出端強度試驗機,濕漏電流測試系統,機械載荷試驗機,冰雹撞擊試驗機,旁路二極管熱性能測試系統,熱斑耐久試驗機,EVA交聯度測試儀
實驗?zāi)康?/span>:
評價組件在潮濕工作條件下的絕緣性能,驗證雨,、霧,、露水或溶雪的濕氣不能進入組件內部電路的工作部分,如果濕氣進入可能會引起腐蝕,、漏電或安全事故,。
實驗裝置
應滿足下列要求:
— 對于面積小于0.1m2的組件絕緣電阻不小于400MΩ。
— 對于面積大于0.1m2的組件,,測試絕緣電阻乘以組件面積應不小于40MΩ·m2,。
BR-PV-WLC Wet Leakage Current Tester with Spray System
Implementation of standards:
IEC 61215:2005 & Ed.3, IEC 61646:2008, IEC 61730-2:2004, UL 1703:2008, VDE 0126-5:2008, VDE 0126-3:2009...
System composition:
Basic framework: Insulating water slot air-conditioning (or constant temperature circulating cistern) detergent conductivity detector surface tension determine instrument spray frame program-controlled insulation voltage tester with Light-Screen safety protection system
Insulation voltage test explains:
IEC 61215/61646/61730, were not given insulation voltage test pass/fail discriminant basis, we quoted UL 1703 "Dielectric Withstand Test" by - as Test discriminant basis, namely: Compression test stage no more than 0.05 mA leakage current. In addition, the program, should not be greater than pressor 500V/s, module belong to capacitive load, we find that moment caused by leakage current charging electric current exceeds.
The insulation and spacings between live parts and accessible conductive parts and between live parts and exposed nonconductivesur faces shall withstand the application of a DC test voltage equal to two times the system voltage plus 1000V without the leakage current between these two points exceeding 50μA DC. The voltage is to be applied in both polarities.
a) 一個淺槽或容器,其尺寸應足夠大到能將組件及邊框水平放入其中的溶液,,有符合以下要求的水或溶液
電阻率: 不大于 3500Ω·cm
表面張力:不大于 3Nm-2
溫度: 22℃±3℃
溶液深度應有效覆蓋所有表面,,不要泡到?jīng)]有為浸泡而設計的引線盒入口
b) 有相同溶液的噴淋裝置。
c) 可提供500V或組件系統電壓的較大值 ,、有電流限制的直流電源,。
d) 測量絕緣電阻的設備。